Dear friends / Experts
I want to remove the collet from this tiny little motor ( 19 gms , 2mm shaft)
1. what i can see is that it has a tiny shim of copper which is binding it to the shaft.
2. there is no hex screw used in this collet
What is the best method to remove this ?
Reason : original collet is for a 4 fin prop and i want to mount a gws or apc prop with prop saver or 2mm collet
more pics
bump
Hey Manpreet,
you need to post clear pictures these are blur and I am sure no one can see the small collar you are talking about, if it's like a C Clip which motors normally have then you can use any negetive screw driver to pop it off eaisly.
Hellyflyer
+1
the pictures are totally out of focus to comment.
solved..
cut the collet midway and then pulled out the balance.
{:)} Dremel power