Great work...!!!!

thank you Thushar..hold the inspiration..and make lots of crafts yourselves..what's a lost here..? nothing..even after a good crash you loose only a prop about 30 Rs..and take an other motor..fly again..

Ok. I will try measuring ampere through this method. I knew I have to connect Multimeter in series but was a bit confused about where does it goes between motor-ESC or Battery-ESC. Now my confusion is gone. Thanks a lot Roopesh Sir.

And any idea on how to remove the stock winding from brushless outrunners without damaging the stator.
I guess the winding is dipped in epoxy or something to protect from loosening.

Thanks.

Sure Sumeet..i will add all things one by one..its all easy to remove the older windings..and please do not add the meter in between motor and esc..but always, in between the Positive terminal of battery and ESC..because from ESC to Motor, the output will be pulsed..but from Battery to ESC..is solid..DC..so, the ESc drops from battery, including the BEC..load..tp RX..

 

yes..do not throw your CD drive units..we can make lots of crafts with it..

i would love to see a flying air craft with this motors ...

Vineet..its all ok..but i need one to fly her..its 3D one..with 16 inch wingspan..

19aug12
was reading this thread today, could not see the video, is there any expiery date to the attached video or the thumbnails?
experienced the same on some other threads other places also? as thte note says attached video but now there is nothing in the window.
new to the forum, do not the working procedures-pravin