Hi, I have receintly bought readytosky 40A esc from Robu. after connecting the Esc it is not worling properly, it jutters, as it connect to 2 wire, when i have connected all three wire to motor.

Any suggestion or trubleshoot, please share it.

Quote from: santhosh.xsb on July 02, 2024, 02:33:30 PM
Hi, I have receintly bought readytosky 40A esc from Robu. after connecting the Esc it is not worling properly, it jutters, as it connect to 2 wire, when i have connected all three wire to motor.

Any suggestion or trubleshoot, please share it.

This is usually the sign of a poor solder joint.
Resolder the connectors on the motor.
Try with another motor.
Make sure the tx is on and throttle is at idle before powering the Esc.
If still no success, phone Robu.in. I think they will replace.

thanks for your responce, i have tried with different motors, all behave same, if i use different esc for the same motor it work fine.

Also it has been more that a month is bought, i dont belive Robu will replace,

do you have suggestion for better ESC.

If u are looking for better esc I would recommend getting something by neutronrc, foxeer, T MOTOR, Hobbywing