can i use one ESC for two motors or should i use Two ESC's :headscratch:
[Admin Note] Topic name updated to a meaningful one, and moved to the right board.
check this..
http://www.rcgroups.com/forums/showthread.php?t=1357604 (http://www.rcgroups.com/forums/showthread.php?t=1357604)
hii
guys i have tried this long ago
I used e-max motor and 40 amp ecs,I used y cables to connect to motors
at the last i lost my esc burn out :banghead: :banghead: :banghead:
I strongly recommend not to do soo!!!!
kh
With all logic it is possible to have 2 motors connected to one ESC.
Connecting motors via Y cable ( usually the servo cable) is a bad idea.
points to be seen...
1. ESC capacity to be more than double the motors can draw since the winding will be in parallel which would make resistance in parallel .
2. motors should be identical
3. motors may not run at same RPM.
regds
so basically i should use a 60 amp ESC foe both in place of a 30 amp for both... because 1 motor requires a 30 amp ESC
yes... it will work.
But
Why you need to run motor... if its a plane i will suggest not to use one ESC for 2 motors.
regds
Saurabh
ohk.... thanks bro !! but then can i put 2 ESC's in 1 channel only??
and the battery should be doubled or the same mah!!
yes you can put 2 Escs on same channel.... there you can use the Y cable.
cut one of the red wire ( +ve ) to Receiver.
thankyou bro!!
Put both ESC on one channel via Y-Cable and it will surely work..(and don't forget to calibrate throttle range of both esc)
goodluck :thumbsup:
regards