Need help setting up ESC

Rajesh14305 · July 07, 2014, 07:40:06 PM

Hi i have a 3cell20c lipo working correctly.turnigy aero drive 1000kv motor with 18amp esc.flysjy ct6b .before my motor was working.but after a month now my motor dont starts.i thought there is some thing wrong with the tx or rx.but when i put a servo to throttle ch it works but my motor does not starts only esc is beeping.

girishsarwal · July 07, 2014, 07:47:15 PM

Try consulting the manual for the ESC... the beep pattern reveals a lot of information. Maybe it just needs calibration.

Rajesh14305 · July 07, 2014, 07:51:48 PM

Sir can u tell how to caliberate esc.btw my baterry showing 11.4volt now can this be a problem .coz my esc is pf 3cell

Rajesh14305 · July 07, 2014, 08:02:44 PM

2 minutes nefore i again tried .this time it run and beeped as dong before.but now it runs even when my throttle stick is at bottom most position

girishsarwal · July 07, 2014, 08:41:14 PM

Please calibrate. Your ESC manual should have instructions on how to calibrate. Calibration procedure varies across ESCs

ayub · July 07, 2014, 11:41:57 PM

I think your throttle channel at radio is in reverse mode, check it

Rcjabalpur · July 08, 2014, 12:29:53 AM

if it is going on at the lowest level of the stick then either your channel is reversed or your trims are not set if not this then trouble shoot your esc

Need help setting up ESC

Rajesh14305

girishsarwal

Rajesh14305

Rajesh14305

girishsarwal

ayub

Rcjabalpur