HI ALL

i just received new esc it is
Turnigy TY-P1 25Amp Brush-less Speed Controller

using a 3s lipo 1050mah
motor - cf 2822 1200kv outrunning

now the battery is not yet fully charged ( using as  bought )
i first connected the bind plug to the receiver and connected the esc to ch 3 also connected a servo to ch 1 ( for checking )

then turned the TX on then connected the lipo to the esc
i got it bind successfully TX  to Rx
checked the servo ( it worked fine )
NOW THE PROBLEM IS THAT

when i connect the motor to the esc and turned on the system on
i hear the beep sound after it is set
i gave a little throttle

but there is no effect at all
the motor didn't even move

what could be the problem 

what i think is :  as it is an programmable ESC   
                        so it cuts the throttle at low voltage ( and as the lipo batt is not yet charged )
                        could it be an issue
   
or i am wrong 

suggestion form all welcome                        

There is a signal problem. Try Ch2 and Ch3 both, sometimes the Throtle output is switched b/w the two channels.

yea i tested it in ch 2 the motor moved a little and then rest
as it rest the esc started a rapid "beep-beep-, beep-beep sound !

and i also checked the esc manual it said 􀂐 If the very rapid "beep-beep-, beep-beep-" tones is emitted, means the input voltage is too low


now how to bring it in ch 3 back or it will be OK in ch 2 
 

here is the manual

http://www.hobbywing.com/upload/manual/ESC_e.pdf

YOU HAVE TO PLUG THE esc INTO CHANNEL 3  CHANNEL 2 IS FOR ELEVATOR

yes i tried it in ch 3 at first but there was no moment at all

as  anam sir  told (There is a signal problem. Try Ch2 and Ch3 both, sometimes the Throtle output is switched b/w the two channels. )
and i tried in ch 2 it worked
the motor moved a little and the the esc started continues beep sound
which i came to know after reading the manual that "If the very rapid "beep-beep-, beep-beep-" tones is emitted, means the input voltage is too low "

now the thing is that the esc (throttle ) is  working in ch 2
how to make it work in ch 3 
i will charge the battery and then check it again

will update the post after charging the battery

thanks every one 

WHICH RADIO ARE YOU USING...NEVR HEARD OF THROTTLE ON CHANNEL 2 

What's up with many using capital letters all the time now ?

That is happening in most of the HK radios, be it turnigy 9x or the latest 6DF. Akshay, you have used the futaba 7C, that is a good quality radio and does not have such problems...

If you are unaware of any such problem does'nt mean that it does not exists...

And yes anwar bhai, I agree too... the all caps posts are a bit disturbing...

mine is 7C anam bhaiya
sorry for the caps lock ...i didnt noticet the caps as i am typing from my mobile sorry for the inconvenience caused 

I do not know why this defect is present in some radios... JUST A THOUGHT, can it be due to conversion of mode 1 to mode 2??

the radio i am using is  turnigy 9x

After choosing "Stick Mode - 2", please calibrate your throttle for the ESC to run properly. Connect ESC to Channel 3. Calibration should be defined in the ESC manual.

When you select Stick Mode 2, it will ask you that you want to reverse the throtle. Click yes.