have following items to sell.

1. HK X230 xcopter Rs.3500 + shipping
http://www.hobbyking.com/hobbyking/store/__26587__X230_Mini_Quadcopter_Combo_w_Motors_ESCs_Propellers_.html

One of the motors gets hot at full throttle. I have changed original 2.5mm male bullet connectors of ESCs to 3.5mm bullet. Original props broke during testing. So I have put GWS 5030  with ring adapters stuck in shaft hole.  

2. HK V2.1 Atmega168PA multirotor control board Rs.900 + Shipping

http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=19534


3. 3S1300mAh 25-50C Turnigy nano tech batt. Rs.600+ Shipping
http://www.hobbyking.com/hobbyking/store/__11903__Turnigy_nano_tech_1300mah_3S_25_50C_Lipo_Pack.html

The batt. has gone through 4 charging cycles.

4. XT60 to 4 X 3.5mm bullet Multistar ESC Power Breakout Cable . Rs.175 + shipping
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=25480

I have done some modification on the b/o cable. Please see the picture.

The reasons for the sale are time constraints and arranging funds to repair laptop.

Interested friends please send PMs. Please note that prices are not negotiable as I have already factored any defect or modifications I have made.

Regards

Vishwas

"So I have put GWS 5030  with ring adapters stuck in shaft hole."
what do u mean by this.?

Quote from: sajid6300shaikh on March 22, 2013, 11:23:13 AM
"So I have put GWS 5030  with ring adapters stuck in shaft hole."
what do u mean by this.?

Dear Sajit,

Prop shaft hole is bigger than the motor shaft diameter. So I have glued plastic adapter rings which came with props with CA.

In your email to me you have asked me if I was able to fly it. The answer is no!! The copter showed lot of yaw movement. Then one of the motors was starting late/slower. Hope this satisfies your query. As requested in your email shall I book the frame combo and breakout cable for you??

Regards
Vishwas

n whr did u glue dat ring.?
to shaft or prop.?

Quote from: sajid6300shaikh on March 22, 2013, 02:45:17 PM
n whr did u glue dat ring.?
to shaft or prop.?

To the props.

ohk.
I'll tell u final tomorrow.

Hey vishwes, does the motor still heat up after you changed the cable? Are Escs included? Can you sell those w/o the frame?

Sent from a potato using tapatalk 2

aniket- buy complete with frame, because these motors are carefully picked for this size and weight quad which is too small. This might be a good quad for learning.

Hmmm... And also, can you please tell me what all is included on the frame?

Sent from a potato using tapatalk 2

Dear Aniket,

My apologies for late reply. Actually, I just informed one of the rcindian that I am backing out from the sale due to poor response. But let us see. My changing the bullet connector has nothing to do with motor heating up. As I had one breakout cable with 3.5mm connector, I change ESC's connetors to 3.5mm.

Now I am selling the quad with original configuration frame, ESCs, motors, props(please see original post), and power distribution board(never used).

Regards
Vishwas

is it still 4 sale 

Yes!!! only if you do not negotiate the price.

Vishwas

why are you not replying to pm?

hey! is the battery sold? also, the cost of the battery on HK is 500..

last active march 26.... :/