Hi friends...
    want to sell 25 to 30 Amp Hobbyking ESC.. At low cost Rs. 500/- only with free shipping any where in India... pm me.

Hey Fellas,

Is it necessary to give 50Hz PWM to ESC..? If I give 500Hz to ESC than what differs..?

And outputs of 30Amp ESCs and 25Amps ESCs to the same 930kV Brushless motors differs in what way?

Hi rc..
   There are some different... its depend to ur tx & the Lipo Bat. But the 25 to 30 Amp ESC recommended to the 1100 to 2200 kv out runner motor. And the prop 9*5-10*5, 7.5-9*5, 6*5-8*4,7*4. As per my experience.. I think,this setup was the proper flying. Look one thing - Hi motors - then use the low prop. & low motors - then use the high prop. If u don't trust the ESC, than u use The ESC Programing Card makes short work of programing your ESC.  No longer do you need to mess around with the throttle stick on your radio.  Instead, just plug the wires that go to your receiver into the top of the program card and plug the battery into the ESC and the card will light up letting you know what settings are currently being used.  To change the settings, simply scroll down by using the buttons located on the bottom of the card.

do you still have the esc s?

do u have the esc's.can u book it for me.