Free giveaway for
a 3ch ir Helicopter circuit.
contains no motor or battery
to simplify its just a pair of 3ch ir tx rx system.
anybody interested so me your address.
Ankit, i am interested. Please let me inform the postage.
ok sir booked for you
Hi Kalyan,
i request if you can alow me to take this board as my heli is dead and my son is asking to purchase a new one which is not possible immediately.
check my thread
http://www.rcindia.org/wanted/modelart-rc-heli-pcb/msg48138/#msg48138
i just need the PCB only.
Sandeep
Ok Mr sandeep if Mr kalyaan leaves it it'll be sent to you.
mr kalyaan i request you to reply please
hello all . i jus need the circuit diagram and the components used . . i'll make my own board.
Priority wise list-
Mr kalyaan - i don't know why he needs it but i an sure he'll surely do something really innovative with it.
Mr sandeep - as stated above .
Mr victor - broke his tx now needs a new one or a circuit diagram to make one.
if the first one refuses to take it it'll be offered to the second and then third person.
Me Kalyaan has asked me to pass this on to Mr sandeep sir
I request Mr sandeep to Pm Me his address!!!
Hi,
Sandeepm, As in office, I have no internet connection, I cannot reply. Of course, I am withdrawing my option. It will be more useful than me.
I have requested this for use in Plane prop (Two) and the back motor connection to Micro coil and magnet for rudder control that can make the plane faster turn. Or the back motor can be used for elevator for faster elevator control while turning only achieved by differential prop speed.
But Sandeepm's requirement is more than my experiment. So forwarded.
Sandeepm, Speedracer, Please Check PM.
Thanks
Hi Kalyan,
Thanks for your efforts in leaving the kit for me (actually for my Kid), he says thanks!
Sandeep
mod please lock the topic.
can i get it...because i need it for a school airshow...i am building a c-17 model and that too a scratchbuilt one....low on budget... pls can you give it to me????
Please look at the previous post. If he wants it locked, the deal is done. I'm sorry but I'll have to go ahead and lock the thread.