Hi,
i had 25 flights in this heli
in this flight i fixed a keychain camera and tried flying.
it started to pitch front when i take off i couldn't control it and crashed
i don't know what caused the crash.
i am fixing it, waiting for some spares.
:)
http://www.youtube.com/watch?v=NqULsXZ05AI (http://www.youtube.com/watch?v=NqULsXZ05AI)
I feel its that Receiver issue or a lose connection . :-\
I had problem with that rx many times due to improper placement of antenna .
i am using rcb 7x
and in rx before this flight i tied both the antennas together and flying
in this i separated both and fixed in opposite direction but it crashed :(
I Don't have much idea . Do check the instruction by rcbazaar or any other fellow member.
I dont use that tx anymore
okay dhruva thank you
:)
there could be many reasons,
1. Either of your servo wire went loose. Yesterday i faced similar issue with my rudder, when inspected turned out to be a loose wire.
2. Press the master/slave button on the receiver, which would enable slave circuit.
3. Might be one of your servo misfired.
CG is disturbed because of camera ? ??? ???
@kumar he is using a keychain cam , center of gravity should not be a concern.. anyways
dinesh please dont use that woodies on you fbl, they are not perfect for so. Get a fiber one and where did you mount the camera, i hope it was not on the canopy.. too shaky :)
i checked after the crash but nothing was loose and servos worked fine,
could be rx problem. i will check that.
cg is good as its weight is negligible
thanks avesh i will replace it with cf blades and i mounted the camera under the canopy.
camera was attached to the canopy.
thanks avesh & kumar
:)