Hello,
I recently have purchased HK450GT PRO V2 Heli From Hobbyking. Its a FlyBar Heli. As part of electronics I have purchased Avionic X5 Gyro, as it can be used for both flybar and flybarless helis, as i have a future plan to upgrade it to Flybarless heli. I thought of having some hands on experience in flying Flybar helis initially and then move on to FBL heli flying. But Initially i need to setup this Avionic X5 gyro on my FlyBar Heli. Does anybody using this same setup ? I read the manual completely, but i still have some doubts :headscratch: In manual, they have clearly explained about configuring it for FBL only, there is very less help regarding the Flybar configurations. Seniors Your help is highly appreciated.
Thanks in advance......
Thanks
Kumar
hey kumar i dont know if i missed this but u u only need to do tail setup in the gyro and select flybar heli in gyro leave rest of the cyclic setups just do the tail part i guess 4 steps for tail only servo type servo ,pulse frequency ,gyro sensing and endpoints ,also frst step select flybar gyro ...ur done
Hey Thanks for your help shannon. I tried to do it in the same way, but i couldn't do it. will call you, when i sit before it. Thanks once again....
its quite easy i dont know how can the setup be a problem just a few steps :headscratch: :headscratch:
In flybar mode you can use it as a tail-gyro. Setup is not enough, you'll need special gyro adapter cable (probably sold separately) to use it in flybar mode.
Let us know how the tail holds.
-HTH
u dont need any special adapter cable just plug ur tail servo in gyro and only the rudder and gain gets connected to the rx rest all the servos and esc gets connected to the rx directly
Hope that works :) good luck
soon will try this option and will let you know the result for sure....