dineash these things happen those lengths in manual are just shown as starting reference points the end result u may have different lengths of the rods for perfect swash dont worry adjust the lengths and get the swash level

thank you so much.
 

ur welcome ...u will be sorted once every thing is approximately  level

again the problem.
i changed the links and at mid stick swash is level but at negative and positive its not level? aileron and pitch not level in negative and positive

which servo is moving more ail or pitch

can u also send me a picture of the swash from the front of the heli full positive and negative

full negative aileron and pitch not level (pic 1)
full positive elevator is not level(pic 2)

Elevator is fine.... I'll have to check again but use travel adjust and increase travel on pitch servo only in right direction and then ccheck again and c if it solves ur problem

its no working.
same problem after changing travel adjust.

Are u increasing the travel in the right direction

yes i tried in both direction but not happening.

when setting up the heli
i kept the servos in different way.
i swapped the aileron and pitch servos.
is that causing these problems?

No I don't think so it should be a problem as long as u have connected the servos in the order they have to be connected Idoubt u will have a problem..... U actually ddon't need to bother cause ur not going to use full positive and negative so I think u should finish ur set up... I try and c what can be done for uneven servo travel

okay thank you.
i couldnt find anything please check
thank you

hi dineash i looked around dont worry bout that the gyro will compensate automatically for the servo one of the reason there is no EPA in tht ...so as long ur swash is center at mid stick ur good to go

okay thank you i will check again everything and go for a maiden.
thank you so much

and i got this manual
http://www.helifleet.com/manual/c824:m259/align/450-3g-fbl-en-pdf

in this the linkage rods are same but the ball links are different.
i will try this too.

Hi shannon,

now i have a weird problem,
after leveling swash and 90 servo arm at step H, once i exit the setting the swash is not level at mid stick and pitch curves are linear.

is not level i dint get u when u are out of programming mode ??

which tx are u using

yes, when in flying mode its not level. it is on a flat surface and linear pitch curve.
i am using RCB 7X

ok have u selected no mix or 1 servo in swash selection right

yes its 1 servo in swash selection.

may be ur servos are not moving in right direction reverse them

when ur throttle stick is in the middle the servo in the centre leave it the servo which is gone up or down reverse it u will get swash centre

its moving right.
but i dont know what is the problem now.

reset ur gyro and tx and start over dont worry ....start slow it happens