here is the updated 450 v2 with v3 tail assembly and metal tail pitch slider. test is remaining due to faulty tx.

Hi avesh  pls buy the part i sent u the link of cause rc bazzar does not have it seperatly vertical stbilizer mount

ya , they just provided single sided mount,  thanks shannon

Is this upgraded tail pitch slider smooth? I had purchased this, but found it useless since it was not smooth when tightened to the tail unit.

u have to file it from top but i dint do it for some reason it did not give me a good feel so never used it 

Ok - if you are able to remove the bearings, just add a washer between the two bearings - see if that helps

I have used the dual point tail pitch assembly from ALZRC, and its decent - but its not available anymore.
Unfortunately, the tail pitch assembly from ALIGN is only for TT, not for belt

no the assembly is also for belt there are two versions check on helidirect and other sites

vwinrc has a good dual pitch slider but they will give you the whole tail unit ...quality is good and slop free tried and tested by members on helifreak ....only available on ebay and some sites

hiller one i bought is not balanced or bearing issue, when i mount it the tail vibrations are high, not that much of a difference in v2, slop still there.

Quoteno the assembly is also for belt there are two versions check on helidirect and other sites

ALIGN has two versions PRO and PRO V2 - both are for TT

The metal plate (which holds the bearing) is smaller on TT, so these will not fit the belt versions.