Hai guy... My lama v4 is not responding to any input from the transmitter... it only responds a bit to the rubber input that too in a wrong way... my tx battery was fully charged and my lipo was too... what shall i do?? please help...
Rubber input ? Please clarify.
In any case, please check the battery outputs, as just putting them for charge may not always mean they are properly charged.
Stupid of me, I just realized that you may have meant rudder input :banghead:
So do you mean the blades are spinning but the left/right/etc controls are either not responding or going in the wrong directions ?
Hi,
Please check the connections to the main motor, also see if there is anything blocking the movement of the gears.
For rudder input check the reverse switches on the remote to ensure they are in the right direction
Hellyflyer
Sreedhar - Any updates on this ?
i too faced a lmost a similar problem with the lama v4 purchased from rotor chennai,the response was not good whn i contacted th contacted the rotor guys,its lying on my table for almost one year..
santhosh
Oh :( We should have tried troubleshooting it together !
Exactly same symptoms ?
Anyone please tell me that lama v4 is a good one? :headscratch:
I already ordered this one :banghead:
Please :help:
LAMA v4 (and later) are probably the one of the best ever introductions anyone can get into RC. They are great as the very first RC aircraft for any absolute beginner.
What happens with certain individual pieces is of no consequence, as there are multiple brands of the same, and the it could be user error or a few defective units out of thousands. So rest easy about your decision :)
Thanks Anwar :salute: