6 ch fly sky with wolfpack 30 amp 5v/3amp ESC ....
motor is sky surfer v3 motor..
motor is now working properly..its doing break dance..

Quote from: krupashree on January 27, 2017, 06:00:00 PM
motor is now working properly..its doing break dance..

If it is now working properly, then all is well 

If it is not working properly but doing 'break dance', the most likely reason is a break/poor solder joint in one of its three wires. Check continuity. At least try pulling/pushing one wire at a time to locate.
Often dry solder in one of the bullet connectors...

Best of luck.

I had same problem.
Iyer sahab has correctly pointed out the solution.
Its experience that speaks.

okkk i am going to try...