6 ch fly sky with wolfpack 30 amp 5v/3amp ESC ....
motor is sky surfer v3 motor..
motor is now working properly..its doing break dance..
Quote from: krupashree on January 27, 2017, 06:00:00 PM
motor is now working properly..its doing break dance..
If it is
now working properly, then all is well ;D
If it is
not working properly but doing 'break dance', the most likely reason is a break/poor solder joint in one of its three wires. Check continuity. At least try pulling/pushing one wire at a time to locate.
Often dry solder in one of the bullet connectors...
Best of luck.
I had same problem.
Iyer sahab has correctly pointed out the solution.
Its experience that speaks.
okkk i am going to try...