i want to build a quadcopter and put a camera for capturing photos and videos.
i did some small research and finalised my parts list. here is the list that i finalised

Frame:
  1/2" width, 1mm thick, 30" long square aluminium hollow rod- 1  (60g)
  1/2" width, 1mm thick, 14.5" long square aluminium hollow rod- 2 (30g each)
  7.77" square plywood plate- 2 (100g each)
net frame mass is 320g

electronics:
Emax MT2213 brushless motors-4
Hobbywing Skywalker Quattro 25Ax4 UBEC Brushless ESC
Hobbyking KK2.0 Multi-rotor LCD Flight Control Board
Turnigy nano-tech 2650mah 3S 25~50C Lipo Pack
Turnigy 9X 9Ch Transmitter w/ Module & 8ch Receiver (Mode 2) (v2 Firmware)

i ll be building the camera mount latter. But first i wanted my quadcopter to fly so that i can learn how to control it.

yes , you got almost all .. get the tools and start building, Wish you happy Independance Day..  Nice day to start new project... All the best

you will also need
10CM Male to Male Servo Lead (JR) 26AWG (10pcs/set)

other things seem good. good luck buddy

thank you... and happy independence day...
i went through the forum and found that there was problem while importing tx/rx system. i saw in some post that they are held by customs officials. in that case what to do?

and can you suggest me a charger for my lipo batttery?

i never ordered one. buy locally even though u will have to pay 2-3k more but its safe and better.

Turnigy 2S 3S Balance Charger. Direct 110/240v Input

This ^ is what i used for few months with my 3S battery. excellent charger.

if you want to upgrade to 4S or 5S battery in future go with IMAX B6~

Get the charger from here-
http://www.rcbharat.com/battery-chargers/191-imax-b3ac-2-3s-pro-lipo-balance-charger-direct-110-240v-input.html

and radio-
http://www.rcbharat.com/4ghz-systems/215-fs-t6-with-lcd-backlight-display.html
http://www.quadkopters.com/product/flysky-fs-t6-2-4ghz-6ch-transmitter-and-receiver/