Have tried everything to no avail. I'm using a FS CT6B and it works fine with my F450 running APM. My board and Rx are being powered correctly and I can even move my motors through CleanFlight.

The only signal that is detected is Auxiliary 1 (CH 5). Nothing else is detected.

What do I do?

Have you selected rx_parallel_pwm in the configuration tab?

Yup.

Found the problem, the channels are getting shorted. I checked with my DMM without connecting the receiver and the channels are not bridged. However whenever I connect the receiver to the Naze32 the DMM shows that the first 3 channels are bridged.

Why is this happening and how do I stop it?

using rev.5 or rev6 ?

Quote from: nite on March 07, 2016, 01:13:10 PM
using rev.5 or rev6 ?

Rev 5.