Hi, I bought the naza lite from HobbyKing and I can't connect it to my PC. When I try to do the stick Cali, it just doesn't work. Maybe the controller is not talking to the RX or my PC. Even the lights at the bottom of the assist window don't light up. What software should I be using because I can't find a lite software, all I see it M-lite software.
Please help me out.
did you connect it to the battery ?
dji flight control boards need to be connected to the battery before connecting it to pc
hope this helps
if you need any help
fell free to call me 7678013993
Happy Flying
Regards
Chintal
Rcmumbai.com
Yes, I connected the battery too.the thing is that I can't find the lite software which might do the job
http://www.dji.com/product/naza-m-lite/download (http://www.dji.com/product/naza-m-lite/download)
you need to donwload
assistant software and its drivers
first of all install the drivers while lite is connected to the pc
and then install the assistant software
REGARDS
Chintal
Rcmumbai.com
the led is rapidly blinking orange, which means that it cant get receiver signal. i use the frsky module
First of all read the manual so that you dont end up doing anything wrong
What type of signal output does ur reciever give ?
Sbus or ppm ?
Change the type of radio type in the assistant software
And did you calibrate your naza lite compass and radio
1. Make sure that the Rx is binded to the Module
2. Make sure you have downloaded the driver. http://download.dji-innovations.com/downloads/driver/DJI_WIN_Driver_Installer.exe (http://download.dji-innovations.com/downloads/driver/DJI_WIN_Driver_Installer.exe)
3. Use the DJI Naza Lite Assistant Software Only. http://download.dji-innovations.com/downloads/naza-m%20lite/NAZA-M%20LITE_Installer_1.00.exe (http://download.dji-innovations.com/downloads/naza-m%20lite/NAZA-M%20LITE_Installer_1.00.exe)
4. The connections between the Naza and Rx are a bit different. The brown wire (GND) is towards the sticker (TOP) and not the other way around.
5. Select Traditional in Tx Setup page.