emax 250 cf frame is very well made and has a good amount of space  i recently crashed my Diatone silverblade 37  and was unable to reuse it so salvaged all the electronics and moved it to the emax 
enjoyed the build 
used velcro to mount the esc's on the bottom plate and had to cut little heat shrink to get a good fit also need to make sure there are no leads touching the carbon fibre  as it can cause a short
Parts
1) Emax 250 cf frame
2) Naze32 acro
3)12amph afro opto esc
4) multistar elite 2204 2300 kv motors
5)turnigy bec
6) hk pdb
7) Leds for orientation blue white green & red

nyc build..

waiting for flight video if you can please upload nice build

Thank you very much Mr Gunnu like your black sheep Build &  Mr. Cyberhack ☺
Will post he video soon

welcome 

Nice build Wingman100, what lipo are you using for this quad ?

Thank you using 2200 Tatu and a 1550 genace 3cell

Where are placing your lipo? back or middle on top? I have FPV setup, so i have an vtx at top, and only small 1300 battery fits, but now i dont have a lipo seraching for a new 1300 lipo cannt find one...

yes i am placing the battery on top ,i guess you  want to keep your battery safe 

you can use Velcro and straps to secure vtx as its easy to remove it when you want to shed some weight, for batteries check out this site
http://rcmumbai.com/index.php/product-category/multirotors/batteries-multirotors/

thank you ,, i found some in that link, its 25c's ...

Yes they 50c & 70c also in  2200mAh though, you can try mounting the flight controller board right behind the fpv camera to free up space for your battery

How much all this part cost? & in a 2nd picture that green pcb what is?

Quote from: NirajD on September 23, 2015, 05:20:56 PM
How much all this part cost? & in a 2nd picture that green pcb what is?

thats the PDB - power distribution board .... looks like he tried to insulate the solder ends...