greetings
dear readers
i got this board
http://www.quadkopters.com/product/crius-multiwii-se-v2-5-with-ftdi-and-usb-cable/
i unable to start with it...
plz help to configure this board,,,
i wanna to configure this board for tri....
:help:
thnks
manish
09970079728
I can help you with multiwii...ARUN has experience with this board... He too can help you...
sent by Jarvis
Hi Manish,
I bought the same from quadkop, i works good. But to start with you may feel it difficult coz of multiple versions and boards floating on net.
No probs,
check the sections in code.goo.../multiwii
For calibration i am using multiwii guiv2.3
I ve few document downloaded from google coulf share upon request.
Also FYI I have interfaced wifi to the uart interface in place of ftdi, which helped me monitoring the sensor values at flight.
Even i bought this board i need help im cofiguring it
one more doubt i have is do we need an ESC for this board
Yes, you need an ESC(20A-30A) to control the BLDC's... MultiWii just sends the control signals(PWM) to the Electronics Speed Control(ESC) which controls the speed of your BLDC inturn.
thanks i bought a hobbywing quattro ECS
hi i hav one multiwii board which was config for x quad but unable to make it run with flyskyct6b............can anyone help me out...