Text only | Text with Images

RC India

RC Models => Multirotors => Topic started by: Ribz on December 06, 2014, 12:42:43 AM

Title: how to make a cable for ublox 6m neo
Post by: Ribz on December 06, 2014, 12:42:43 AM
this is a thing without compass, the fancy green chip
i lost the cable, but i have one to twin cable for gps with compass
can i directly solder wires in gps? can i possibly make it from latter cable in anyway?
Title: Re: how to make a cable for ublox 6m neo
Post by: sooraj.palakkad on December 06, 2014, 12:48:07 AM
there is no problem soldering wires directly, but you should know which wire goes where,
Title: Re: how to make a cable for ublox 6m neo
Post by: akhilzid on December 06, 2014, 01:00:30 AM
normally  ublox 6m neo have 4 pins to connect vcc-rx-tx-gnd

you can directly wires these to flight control board's serial pins
Title: Re: how to setup multiwii aio megapirate
Post by: Ribz on December 06, 2014, 01:39:12 AM
hail you all :) thanks, i did it...does anyone here has experience with multiwii aio?
Title: Re: how to make a cable for ublox 6m neo
Post by: akhilzid on December 06, 2014, 01:40:28 AM
yes i have, its my favorite FC always.........
Text only | Text with Images