kk v5.5 board with quadcopter

[vajaapurv]

i have mounted the kk v5.5 board and sets it with "+" configuration.
Now should i go for direct arming or for any other settings??

[arun.sreelakam]

If you have done with all other setup like motor mounting, propellor direction correction, cg fixing etc then you can arm the quad and try fkying it low and reverse any channel if needed...
All the best..

[vajaapurv]

thank you sir for reply.
i have done all these things.
but when i raise the throttle stick motors are not started on same time.
like one of the motor 4 starts on full throttle.....

[Rahulvyas]

ESCs calibrated?
kk board calibrated?

[vajaapurv]

Actually i have calibrated the escs,but i dont know enything about calibrating escs..
Can you please explain these two terms in brief??

[vajaapurv]

Sir,i have done all this calibration with the pots with changing the value..
But i dont know the exact method...!!!!
please help me bcoz i am going mad for mounting props and hower it....

[kv10]

1) Turn your yaw pot to zero
2) Turn On transmitter
3) Throttle Stick to full
4) turn on flight controller
5) Wait until the esc's beep twice after the initial beeps
6) Throttle stick to off after esc's beep
7) Turn oFF flight controller
Restore yaw POT
9) Now ARM your board & enjoy your flight...:-)