I FINALLY got my Quad ready ... but now im having issue in Arming the quad . What i saw that i had to turn the transmitter right , then down to arm it , but all i get is a blue led when power is connected to the quad and continous BEEPING  .

Back ground :

I have KK Multicopter 5.5 board
Bought an assembled kit from RC Fever :

http://www.rc-fever.com/quadcopter/alloy-450-quadcopter-aircraft-combo-kit-not-assembled.html

PLEASE help , it seems im near yet so far from flying my quad

trim your throttle down to zero and then try arming, might help

I tried it , it didnt help ...

I have uploaded some pics and a video here to show the issue ..


https://www.box.com/s/vitujfw85semprm5cwpc

UPDATE :

Well , this is strange now , The Quad is armed now but i cant get any response from the motors , only the usual periodic BEEP is coming ..

Also , this is Random - Sometimes the frantic continous BEEP comes and then suddenly its get armed but no response from the motor .


I built the quad in a day and was so happy that ill be able to fly it soon . And now the problems here .


Please help me out , you are my ONLY hope .

(a) Depending on your Tx, some channels needs to be reversed

(b) you config looks like for + change it to X might work

(c) Strapping the board with a rubber band seems to be a bad idea

(d) Do not put the prop before you are very sure, these things can be very dangerous

a> ' Reversed ' as in( soory im totally new to this )

b> X .. how will i do that ?

c> I actually have fixed it below , the rubber bands are just an extra precautionary measure

d> No , the props are out now , will take care of that

Hi Gautam
As you have X config loaded, i think your board placement is wrong. The arrow on the board shows the directin. If you have X config, it should be between two arms. For + config it should be pointed to the one arm.

oh , ok ... and what about the arming issues ?

About arming...  http://www.rcindia.org/multirotors/quadrotor-build-thread/msg68736/#msg68736

ive tried it , still doesnt help

Is it FS-CT6B? Try increasing EPA to the max(120). Confirm which firmware you have loaded. Check pots. If your yaw pot is at 0 position, your board will remain in ESC calibration mode and give you beeps. Check tx config as well. Throttle zero position should be downside of the sticks.

yes it is the same model ..

how do i increase the EPA ?

nothing extra done from my side regarding firmware and stuff

yaw pot is at 0 means ?

Tx config in what sense ?

yes the throttle position is downside 0

( sorry im a newbie , but please help )

what about the frimware

i dont know ... the default one i guess ..i didnt tweak anything .,,

ANYONE ! . please help me out here ...

Bump ...

cant figure out , if you are willing, you could send it to me, will set it and send it back with instructions, if you are in  a hurry

OH ! .. this idea is actually good ! ... but wont the shipping will be costly ?