My setup ....
Flysky th9x radio
Boscam 5.8ghz 400mw video tx and Rc
Cheap 51" diy video goggles
Mobius cam for main flight Camera ...
Another Camera looking downwards at the back of quad
Using three way video switch ON it ...
Cloverleaf antenna ON both tx and rx
One 4000 Mah lipo
And one 2200 Mah lipo
360 sizr frame
30 amp eac
Nice Setup. But it looks like you don't have any covering on the battery connectors. Please use heat shrink. Otherwise your battery might catch fire if they come in contact.
Nice build. :thumbsup:
What Ved said is very important, please do follow that. What is your AUW and what range are you getting with this FPV setup? And what are the flight times with the 2 batteries like?
I think he is using hotglue.. over the solder.. its good enough
YES I USED HOT GLUE HEAT SHRINK TUBE GETS LOSE AFTER SOME TIME
2200 mah battery gives aprox 6min and
4000 mash one is 12 min
till now i didnt pushed to its limits but after installing an osd and proper failsafe settings i will give it a long ride (:|~ (:|~ :hatsoff:
Which Flight Controller and motors are you using?
Cc3d flight controller and ... 800-900kv motor
New addition to my quadcopter ......
LED panel lights for night flying ....they are very bright
Take 12v input .....and light Up a whole Room like a 30w cfl bulb
nyc build.. good luck :thumbsup:
and what is the wattage of LED you are using??
regards
2* 4watt led cob light and
1* 6watt light