Need help to assemble kk 2.15 quadcopter
your post is not clear ! please describe your current trouble !
How to assemble kk 2.15 quadcopter kit which comes in so many parts...
http://www.flyingtech.co.uk/sites/default/files/product_files/KK2.1.5.pdf follow this......
First Solder all connectors properly(SOLDER them to esc wires[3] and motor wires[3])
Solder esc wires(2 wires) to Power Distribution Board.
BE CAREFUL WHEN CONNECTING ESC Wires......BE CAREFULL ABOUT +VE and -VE
Connect one esc to kk board(BE care full about orientation of signal wire, ie +ve -ve and signal wire)
And connect Power distribution board with lipo.
This will power on kk2.1.5
Then select quadcopter layout on Board(X or +, X is preffered)...
set kk2.1.5 board's orientation properly......The screen should be at front/north side while the buttons should be at south side........
Set the layout of motors CAREFULLY..... BE SPECIFIC ABOUT M1, M2, M3 and M4......
ORIENTATION OF KK BOARD
M1 M2
\ /
\ /
\ /
[ === ]
[ === ]
[ . . . . ]
/ \
/ \
/ \
M4 M3
BE CAREFUL WHEN CONNECTING ESC Wires......BE CAREFULL ABOUT +VE,-VE And Esc Signal Wires.
(NOW U HAVE TO Connect motors to ESC)
(TO REVERSE THE MOTION OF MOTOR change any two wires..)
MOTOR LAYOUT>>>>PROPELLER TYPE(cw or ccw) AND Number/Size of propeller should be facing upwards(INSTALL PROPELLERS LATER BUT BE CAREFUL ABOUT PROPELLER ORIENTATION)....
M1 Motor should turn Clock wise (And so does the the PROPELLER SHOULD BE CW)
M2.....Counter Clock Wise same with Propeller
M3 Motor should turn Clock wise (And so does the the PROPELLER SHOULD BE CW)
M3.....Counter Clock Wise same with Propeller
The number on propeller should be facing upwards when u install them.......on motors.......
Then connect reciever to KK2.1.5 Board...
BIND THE RECEIVER WITH THE TRANSMITTER
Follow mode 2
Aileron(Channel1) then elevator(Channel 2) then throttle(Channel 3) and then rudder(Channel 4)
Connect aileron of kk 2.1.5 with the aileron pins of receiver. Similarly add connect other receiver channels to kk board ....*******(AND ALWAYS BE CAREFUL ABOUT THE +VE, -VE and SIGNAL WIRE)***********
And do a Receiver test...
See the back of the kk 2.1.5 board.. and reciever For this thing....
Then Callibrate the ACC......
Then callibrate ESC (First remove propellers... :P)
SEE whether if the motors are moving in right direction...... Install the ""respective props.....there size /numbers should be facing upwards....And CW motor should have CW Props
That's a lot Sukhpreet ! Appreciate n value your time spent for this ! Hope this will help that guy
AND MOST IMPORTANT NOTE......Take above information as a reference......!
AND Before implementing read about the related data /instructions first.....Or else u may blow up ur investment......!!!!!!!!!!!!!!!!
AND I WONT BE RESPONSIBLE FOR ANY LOSS :)
Thank you for the appreciation Sir :)
I hope this not only helps him but others too...
Just being helpful to the group/forum which has taught me alot (And still a lot more to go).... Trying to Reciprocate what i have learnt from people and WEB most importantly :)...
In some time i will create a dedicated thread as well :)
thank you so much to all