hi friends,

I have been searching about mounting the naze32 on ZMR250 but struggling

1. Nylon spacers is top option
2. Double sided tape
3. Wire tie

Expert guidance required

Manpreet
9599382710

Use the nylon spacers.

Ashim.

Considering it is going to take time to procure nylon spacers

Quote from: hangingtough on January 15, 2017, 10:16:40 AM
Considering it is going to take time to procure nylon spacers

If double sided tape is available, just use it and goto motors tab in cleanflight/betaflight. Run all your motors at full throttle without props and see the accelerometer graph reading. If the noise is more, you may have to consider other options.

You can also filter the noise more by reducing the low pass filter value in betaflight. Note, more filtering introduces a lag in the actual signal value getting reflected, as a result of filter's RC constant.

Note:Naze32 rev6 is known to be more sensitive to noise compared to rev5. But my Naze32 rev6 is just fine.