i am a newbie!!!!!   

i am making a X-Mode Quadcopter for myself

my components are:
kkmulticopter board v5.5
4 esc HW30A
4 Propellers : 8 inch
4 motors: brushless DC motors 11.1v 1000rpm ( dont know the specifications)
1 LiPo battery: 2100mAh( dont kknow the specifications )
fFS CT6B 2.4 Ghz


these are the photos of my components .

( http://i00.i.aliimg.com/img/pb/137/629/420/420629137_581.jpg )

( http://i00.i.aliimg.com/img/pb/732/058/296/296058732_927.jpg )

( http://rcbazaar.com/images/thumbs/0003596.jpg )

( http://cdn.rc-fever.com/image/cache/0/b3/e7/b3afb09a44517be75571206cdc12.jpg )

( http://www.hobbyking.com/hobbyking/store/catalog/6540(3).jpg )

( http://image.dhgate.com/albu_124191886_00-1.0x0/flysky-2-4g-fs-ct6b-6ch-rc-transmitter-amp.jpg )

i have made the frame and mounted the components as i have seen on the internet.


i have flashed kkboardv5.5 using flashtool as seen in the videos on this site.

http://lazyzero.de/en/modellbau/kkmulticopterflashtool

i used this tool : KKmulticopter Flash Tool V0.76.
i did all as seen in the video.
my firmware was v2.9 xcopter. because latest v4.7 showed some error.
i read on a forum ; go with v2.9 so i did it.( i have no idea about it).


then i have seen some videos on youtube.

for my transmiter recevr fs ct6b, i watched dese videos and did as seen in them along with its PDF manual





again i feel i have done as in d video.


for esc setup i did as in dis video 


since my esc is HW30A i downloaded the pdf and did as in it.
something similar happened. but esc kept on beeping and motor didnt rotate. it only had a small jerk

i havnt connectd propellers yet

now i thot of connecting my kk board with esc n motors den tryin but i failed... i hope i havnt afected any of my components .
the conections n wiring r right i feel... i have done exctly as i videos...


wht do i do now ??

Welcome to RCIndia
And welcome to the KK5.5 Rollercoaster ride. Fasten your seatbelts and prepare for some high G maneuvers while configuring it

Please explain what exactly failed with details.

i wud like to add one mre thing iam also suffering frm same problem does usage of a battery which is 15c1300mah affect a quad of config 930kv motors and 30amp esc.........connected them to kkv2 lcd board but unable to arm it.......
actually i hav a 2200mah battery which seems to be dead so tried 1300mah

Please explain the procedure that you're using to arm it.

sir
firstly i wud like to thank u for showing interest in guiding a beginner.......
i followed the manual which was downloaded from hk website.first time it showed no yaw input but after a little correction it showed that the board is armed.then i tried to arm the motors by moving the throttle stick to left bottom corner but it didnt get armed the i tried various positions but there was no response.

the board which i am using is kkv2.0 lcd

Try moving the throttle stick to Bottom right.

nuthing is happening after i connect my esc to battery den try to fly my copter
all connections r made according to the videos i hav posted