I made this 310 for gopro 3 onboard.
Frame:
310mm X diagonale
2x arms 10 x 10 x 260mm
1 center plate 7.5 x 0.5 x 260mm
4 nuts and bolts, 3M fiber glass reinforced tape, velcro and nylon clamps.
FC: openpilot CC3D
Tx/Rx 2.4 mode PPM - satellite Spektrum
Motors: Sunnysky 2204 2300KV
ESC: Lumenier 12 amp ESC with SimonK Firmware (N-FET)
Props: HQ Prop 5x4
LiPo: nanotech 1A 25C for tests
FPV: gopro 3+, vTx vRx Lawmate 1.2
520g
First tests last we, first crash (radio cut) = 1 prop, second = 2 props.
http://www.youtube.com/watch?v=yvUci6WzIsE#ws (http://www.youtube.com/watch?v=yvUci6WzIsE#ws)
Flight time ??
Quote from: Nithinraj Kotian on June 05, 2014, 08:08:46 AM
Flight time ??
I have made these flights just for test with a 3S 1A.
I think to go with 3S 2.2A.
Nice build very clean. Whats The AUW ?
Quote from: ashimda on June 05, 2014, 10:01:30 PM
Nice build very clean. Whats The AUW ?
Thanks.
With the 3S 1A = 520g
the frame = 120g
You may find the 2.2A a little to heavy, try the 1.5A . Can you run 6" props on that setup?
Quote from: ashimda on June 05, 2014, 10:33:57 PM
You may find the 2.2A a little to heavy, try the 1.5A . Can you run 6" props on that setup?
You have maybe right... will test.
Yes I will also try with HQ props 6"x4.5