I am using emax 12a simoK esc with cc3d ,with all wires intact.I mean ,I have not removed red power wires from three ESCs as many do-keeping only one intact.
Now since I am going to use NAZE 32 funfly for my next build,should I remove them? .I am using emax 12A again.

There is no need to remove if your esc's have built in linear Bec
Otherwise remove the red wire

Thanks Darshan,they have Built in linear or switched BEC.

They have linear BECs , Anil sir, thus you can use as is.

 

Hi
i read your post and found you are working on naze32.
i am using naze32 10dof flight controller 12a blheli esc and done calibration but once armed my motors not rotating in sync. the motor i am using is emax mt2204. can you help me to sort out this.