Hi All,

Requesting help for having my Quad (DJI 450 frame) up and flying.

The connections are quite clear however initially the motor failed to arm, though LED is solid green.

Tried many self help topics, but it doesn't work.  If there are any paid help available in Bangalore, would go for that.

Here are the specs :

1. Frame : DJI F450
2. Controller : DJI NAZA M LITE
3. Motors :Sunny Sky X2212-13
4. Receiver TFR 8 SB
5. Tx : Futaba SG14
6. Battery : 2600 mah 3 S

Do let me know if more information is needed.

Thanks

Did you find any answers on your own ? This place does not seem to have the expertise to guide newbies Or else the so called knowledgeable people are flying too high to come down to earth for us. I am also stuck similarly. Only my transmitter is different fs i6. The naza lite assistant refuses to talk to my f 450. The esc's are calibrated and rotate properly. The led turns green and stays that way.
can you guide,if you found the answer ?Thanks
shrikant prabhu

Hi shrikant,
If you have a windows 10 or 8 operating system then the assist software won't communicate with the naza as there is driver issue .



Use that method and your naza will communicate with the assistant software.

The same problem was there with an FC40 phantom operator few months back and same solution was given

Thanks Mohammad Naveed, for the tip. I had not succeed implementing the method due to my tech inefficiencies. Good news is that at last I got it to connect with pc. using this method in the link below. Thanks for your response trying to help. The link along with yours  might help others looking for suggestions. Regards

Hi,

I can help and know your problem very well. I am located in Jayanagar Bangalore.
Whatsup me on 9175342600. We can work it out.

regds

Thanks Sandeep. So nice of you.  I have noted your phone number. I am trying to set it up now. I will get in touch for guidance, help when I need it.