I checked it...
Pre arm is disabled but I dint knw why I am nt able to arm

Throttle_min was in d mid so reduced it to zero but stil not able to arm...

I reduced throttle end point from 100(default) to around 70 or so motor spinned without arming but stoped.. No response nw...

can you see "ARMED" message in mission planner as in your replay 190 or Red Solid LED In APM?

Yesterday I was not anle to do it... Will check it today n wil let u knw...

wen I connect to PC and run the motors through the Tx all the motors run at different time, guess it can be corrected by trims..
But if I remove the USB cable it doesnt  get armed!

Need help..!

Hi Harish from Thane

I am new to this club
will you help me in getting some one from Thane who will go for RC plane flying tomorrow near Thane.

Thanks & Regards
Harish
09819093699

I am not anywhere near tat place and its irrelevant to this post as well...

did motor test and it works well at 15% throttle...

but i hav no idea why apm doesnt arm when I remove the USB cable

I'm just reading ur thread today, so i don't know what ur problem is , can u elaborate? , is ur apm not arming even after disabling pre arm ? , ND from where did u buy it ?

Guys its working! I hav no idea hw but it is!!! Maybe I elevated the gps...

But I hav one small prob, all motors run at around 10% except motor 4 which runs like at 20%  or more...
should I have to trim or is thr any prob?

The reason is because the apm was tilted to one side since I had put foam in the bottom as the vibration dampner...
I removed but d apm sits little towards left like in d pic...

Check the video..

Do another esc calibration, for the motor problem if that doesn't work , just reset all parameters ND do the calibration again

Twice I did esc calibration, dint work..
ill do the whole thing once again with apm mounted on the quad..
btw how to erase d eeprom?

Go to the all parameters section of mission planner , on the right u will have the reset all parameters option

Tuk it for a spin and it was really gud!!!
but no video, ill take one if possible..

Hav one issue though..
wen I give throttle and fix it at 60 to 70% it keeps coming down..
but is stable! 

Here  is the video!





with canopy video on the way...!

with canopy!
its too heavy though!