hi friends ,
i buy a naza m lite and transmitter.i configure naza m lite and transmitter both. but the problem is when ever increase a throttle motor could not run.
so what is a problem in ?
or is there and mistake for calibration of naza or tx .
i uploading a video link.
https://www.youtube.com/watch?v=VRzHVT61BQI (https://www.youtube.com/watch?v=VRzHVT61BQI)
hey nik
refer this ...http://www.dji.com/product/naza-m-lite/feature (http://www.dji.com/product/naza-m-lite/feature)
madaquif thank you ... but these link is not help me ...
is there any other option .....
and how to arm in flysky th9x .. because my tx rx dose not arm...
hello.
set your motor idle speed to recommended or higher andselect cut off type to intelligent.. may be this will help you..
if the problem still persist than check your esc wiring.
https://www.youtube.com/watch?v=gW2P6dWs6kA (https://www.youtube.com/watch?v=gW2P6dWs6kA)
Didnt see you arming the motors in your video? And the motors wont run till its armed.
How are trying to arm your copter? Did you calibrate radio?
Manual for Naza has all the combinations for arming and they are different from APM or kk 2,so you must take a look at that. I think you would probably need to set endpoints and trim channels if it refuses to arm after finding the right combination.
Also check what those blinking led lights mean because sometimes pre arm checks(if any in naza) wont let you arm the copter if it goes wrong.
http://download.dji-innovations.com/downloads/naza-m%20lite/en/NAZA-M%20LITE_User_Manual_v2.00_en.pdf (http://download.dji-innovations.com/downloads/naza-m%20lite/en/NAZA-M%20LITE_User_Manual_v2.00_en.pdf)
Quote from: Nik on December 25, 2014, 01:21:56 AM
hi friends ,
i buy a naza m lite and transmitter.i configure naza m lite and transmitter both. but the problem is when ever increase a throttle motor could not run.
so what is a problem in ?
or is there and mistake for calibration of naza or tx .
i uploading a video link.
https://www.youtube.com/watch?v=VRzHVT61BQI (https://www.youtube.com/watch?v=VRzHVT61BQI)
hello . just remove red wire from all your esc and try to arm... it will surely work... and post your experience.. i just red about this problem on rcgroups forum.. for more information check this link..http://www.rcgroups.com/forums/showthread.php?t=1900438&page=68 (http://www.rcgroups.com/forums/showthread.php?t=1900438&page=68)
thanx