Recently I m working on the Project, Vtol twin-copter, any one can help me, with the same.
i had completed all electronics before mounting on the wing i wanted to test but its not working
i had use following configurations
Motors:Avionic M2230/15 KV1780 MICRO brushless motor
Servos:Avionic 22g Metal Gear Servo (AV22A)
ESC: 25amp
Board:HobbyKing Multi-Rotor Control Board V2.1 (Atmega168PA)
flashed with twincopter firmware
when i connected to battery and receiver and stared transmitter its not working
image for project
I can't see the LED on the KK board. Does it switch on after powering up?
no it does'nt, then i think it my be connection problem i need to check board connections
where i have to start my board is not starting after all connections i had check all connections again, motor ESC are working when i directly connected to receiver but when i connected to board all dead
hi,
sandeep from pune.
i am working on same project.
call me on 9175342600
regds
hi,
see my twincopter
pics below
awesome...
what is the specification?
No LED glowing, it means your KK board is not arming.
yap but sandip sir had help me now its working fine im finalizing the project
Very good. so now post the pics and a video too.
ya soon will upload, i got the problem with new rc bazzar lipo, now i had ordered from rcproduct. and waiting for new one
Again got to hear about RCB Lipo's. Now what is the problem with yours one?
Nice
Sorry for my earlier post it was in wrong thread
i had purchased RCBs Lipo, in the first charge its one cell not working the quality of the lipo is very bad and RCbB didnt agreed for that