Hello,
I wanted to know that can I control 4 DC motors wirelessly through Hobby King 2.4Ghz 4Ch Tx & Rx V2 (Mode 2) using 2A L298 based Motor Driver .
2A L298 based Motor Driver http://probots.co.in/index.php?main_page=product_info&cPath=54&products_id=197 (http://probots.co.in/index.php?main_page=product_info&cPath=54&products_id=197)
Hobby King 2.4Ghz 4Ch Tx & Rx V2 (Mode 2) http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=9042 (http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=9042)
http://rchobbyaddict.com/product_info.php?cPath=22&products_id=142 (http://rchobbyaddict.com/product_info.php?cPath=22&products_id=142)
No, Both protocol is different.
You have to use ESC for any DC Motor driving by the RF Tx/Rx.
Else you have to use interface card between the Rx and Motor Driver card.
And the driver can drive only upto 4A, but upto 40 volt whereas ESCs are used for Higher currents (Brushed or brushless) for relatively lower voltages. So, the Motor to be used, needs the supported driver and power supply.
Always keep in mind, LOAD IS THE KING and so calculate from Load to the source.
Thanks