i do not want to give a bad impression of this product , because when i see the transmitter it has lots of feature which realy impress me i realy want this product to be a hit in the market ,

and i realy want this tranmitter for my airplane thats why i am waiting for 1 month to get receiver from rc bazaar and i continue my project .

but it is a biginner
product and rcbazaar should provide some equipment on stock so that we can continue with the project or there should be alternate reciever which can be fixed on this radio

otherwise without parts it is a box with switches which is of no use......

 

Hi friends,
I'm also using RCB7x. Recently I purchased Skysurfer 1400 mm wingspan and assembled it. Now it is ready to fly. One thing I want to clarify is ; when I open the throttle , upto 5 points (or steps) the motor will not start. After 5 or 6 th point it starts. Is this normal or I have to make changes to Tx
Shashi

Hi,
It seems that you need to recalibrate your ESC. I hope the problem would be solved after it.

Although the beep pattern differs from ESC to ESC but the setup and procedure remains same usually.
The procedure for calibration is as follows:
1.) Disconnect the battery and all previous setup.
2.) Install your receiver and connect the ESC wire to the channel 3(Throttle) of your receiver.
3.) Now switch on your radio and increase the throttle to maximum.
4.) Now connect the battery.
5.) You'll hear beep pattern. Although it is somewhat different in different ESC's but on the second beep you need to bring throttle to zero.      Disconnect the battery and connect it again(Keep throttle zero after disconnecting the battery)
Now your ESC is calibrated.
I hope after this your problem would get solved.

Also, set the trims of throttle channel on ideal in your transmitter and then follow the calibration procedure.

Thank you all ... Utkarji .. I'l calibrate the ESC as per your guide.

Do post the video of maiden flight. Did you bought it from RCB?

Sure Sir ... Yes from RCBhartat, Hyderabad.

Oh its RCbharat. i meant Rcbazaar(RCB)

finally i got receivers from rc bazaar and really want to see how this tx perform

anybody can tell me the practical range of this transmitter .

.
 

750meter

Hi,

Is this a PWM or PPM tx?

i have very bad experience with rcb7x first my radio dont come with manual cd and second major problem is rang of radio i crashed my 1 plane because of range issue only 100 feet away from me radio is glitching and lost range i suddenly run near the plane but not recover the plane and break the nose of my plane after crash i checked radio but battery and every thing is ok and then i replace  with futaba 6exap and sold rcb7x at very low price i am disappointed with this radio

when can we expect new stock of Tx/Rx in bangalore AVIONICS ?                         

the range test video on their website says 1.2km

Rcbazaar = out of stock

Hello my transmitter right stick is coming off .how can I fix it? 

.

with every time i fly with rcb7x,i end up crashing, ,first with sky surfer then wilga and now quad, ,you cant take it far,but good for flying in short distances like 50m,which you can trust.

i have this tx along with 4 receivers to test my experimental rc airplane in this price range the product is full of  features and i got full support from rc bazaar pune store to get full supply of receivers any time

this tx do not have any range issue because i fly very high using this tx ,
i found  problem in delta configuration in delta mixing i found controls are working abruptly
and it is impossible to fly airplane in that situation.


i now have a futaba

Quote from: AEROVISHWA on January 16, 2013, 04:26:54 PM
just got my RCB 7X and plugged it up right away.....

individual channel assignment( can interchange channel as required
mode selection ( can be changed into MODE 1,2,3,4- may have to interchange the ratchet inside for the throttle hope fully they can do it for you on request)

link to the Tx http://www.rcbazaar.com/products/1773-avionic-rcb7x-7ch-tx-with-7ch-rx-and-wireless-simulator.aspx

Please note that mode change is not possible in this transmitter as per RCBazzar customer support and they will not change it for you. If you open this transmitter warranty is voided and RCBazaar people will not entertain you regarding this matter.

I recently ordered this transmitter with the hope to change it to mode1 and now stuck with mode2 as I cannot change it to mode1. Mode2 is useless for me and warranty is voided as as opened tx to with the hope to change the mode.

Can anyone have the simulator software for this setup.
I bought this from RCBazaar long back but never used. I do have the CD provided with the product it has only PDF Manual.
If anyone can provide Simulator Software for this... Its really appriciated.

Thanks in advance