2.4 Ghz radio antenna

Started by sandeepm, March 07, 2010, 10:23:50 PM

Previous topic - Next topic

0 Members and 3 Guests are viewing this topic.

sandeepm

Hi,
just wanna know about antenna system in 2.4 Ghz receiver. I have seen many 2.4 Ghz receiver with short length antenna coming out of the box. WHY IS THIS 2 piece? and WHY not ONE?. what is the use?....Is it uses same as standard Main and Aux antenna as used in Wireless connection in Laptops?
Fly high if you have good set of batteries.....!

sandeepm

Fly high if you have good set of batteries.....!

ujjwaana

2.4Ghz radio frequency has a a wave length of 4.92 inches. Normal 'omni directional' antenna  (like one used in Broadcast Radios Receiver,Walkie Talkies etc , AND our Tx/Rx), are usually of the length of 1/4 wave length. That amounts to 1.24 inch long antenna for our 2.4Ghz radios.

the Antenna we get in our 2.4G Rx are antenna + Coax feed wire combined (like the flat cable from your TV to roof top Yagi Antenna for Doordarshan reception). When you remove the outer shield of the coax wire (acting as ground) the exposed 'core' becomes the antenna. The extra length in the feed wire is to let you route the 'antenna' part to a suitable location where you have clear reception. My Futaba 6004 2.4g Nano Rx has just an inch antenna, sans the feeder.

Now two antennas. Take your FM radio, extend the telescopic antenna vertically and tune to a fading station so that you barely listen the reception. Now turn the antenna so that it is parallel to ground instead vertical - you loose the signal completely. The two (mutually perpendicular antenna ) in full range Rx are to assist reception in when plane is in different vertical/Horizontal orientation while in flight.

Futaba and also Sanwa (I believe, owners pardon me if wrong) only uses passive duality i,e they have only one receiver pre-amp section and two redundant antennas connected to them. Others like JR/Spectrum have two separate Receiver pre-amps having dedicated orthogonal antennas

Question: Why not 3 antennas to have true 3-Dimensional coverage ? :headscratch: :headscratch: :headscratch: :banghead: :banghead:
Futaba 8FG Super | HK-450v2 | FA-22 Raptor |AXN Floater-Jet | FunJet | Black Horse Edge 540 | Amp Master 015 | 2.3M Big Brother

sahilkit

antenna radiation is 3-D, imagine a apple cut in half to see the radiation pattern of omni-directional antennas
Today might be a great and wonderful day. It depends on you.

anwar

Some Spektrum/JR receivers can have up to 3 satellite receivers.  You can place them strategically to ensure maximum coverage.

Check out this "PowerSafe" one : http://www.horizonhobby.com/Products/Default.aspx?ProdID=JRPR922
Hangar : Please see my introduction.
RC India forum and me : About this forum.

sandeepm

Quote from: ujjwaana on March 09, 2010, 03:17:08 PM
The two (mutually perpendicular antenna ) in full range Rx are to assist reception in when plane is in different vertical/Horizontal
My Query related to Laptop : laptop also uses 2.4 GHz for wireless communication and the antenna comes out of the main wireless card and runs through the main screen, i have not seen (mutually perpendicular antenna ) but main and aux. antenna comes from opp direction and ends at the same place. WHY ?
Fly high if you have good set of batteries.....!