Hi

I am using a flysky ct6b transmitter. when I tried to apply fail safe mode in my hexa copter the channel 5&6 are not responding. Checked it with t6config software. How can I fix it..?

i don't think ct6b supports failsafe..
regards

i am also facing this problem the ch5&6 have only null operation in t6config when it was new everything was working but when i programmed and mixed some channels for elevons that rotating buttons stopped working

CT6B CH5 & CH6 only works if you configured mix and assigned to any POT or Switch,

In flysky no inbuilt failsafe control so cant work failsafe without flight controller, they will output zero pulse when no signal from transmitter so failsafe works with Naza, APM and Pixhawk, don't know about other flight controllers. for this we need to configure failsafe in flight controllers configuration.

Hi guys,
Could you tell me how the Flysky FSCT6B transmitter and receiver is in general? I mean how is it quality wise? Is it worth buying?

I have one brand new CT6B , sealed packed and willing to sell it.

Its OK does not have any glitches and is affordable.  The Range is good enough for line of sight flying.  I have been using it for about 2 years and am changing my set to a FUTABA T6K in Dec.