http://www.banggood.com/Wholesale-Flysky-Upgrade-Fs-th9x-Fs-th9xb-2_4g-9ch-Rc-Remote-Control-Transmitter-Mode-2-p-47904.html
would this suffice the needs of a beginner in the hobby. would i be able to use this with rc cars too?
I link to bind my Fly Sky FS TH9X transmeter with WL toys quad controller board V939, but unable to do the same. Any body in this forum can help me to compleate my project. :headscratch:
http://www.rcindia.org/multirotors/a-small-diy-quad-within-everyone%27s-budget/
This is the thread that you need to refer to, you can find the bind procedure in the first post itself.
Quote
How to bind the transmitter with receiver/Bind instructions:
1. Plugin battery to receiver LED will flash quickly and stops
2. Keep it on flat surface and LED will start to flash again at a rapid rate
3. Hold bind button on your TX and switch it ON
4. LED on receiver should start to flash slowly
5. Turn off your TX and leave the bind button and switch ON your TX again.
6. LED on receiver should be solid now, which means its binded successfully
Thanx a lot Rishi, I am sucessful by using your method. Thank you again..........Keep posting for begainers.
did you buy this from banggood web site.................
how much custom was paid for this????