how to rebind flysky 6ch 2.4Ghz receiver?

1. switch off the transmitter
2. plug the bind plug into battery port of reciever
3. power the receiver through any other port
4. Press and hold the bind button in transmitter and swith it on
5. The receiver light will stop blinking...
6. disconnect battery from receiver, remove the bind plug.
7. swith off the transmitter

now its binded..
always switch the transmitter on before powering up the receiver..

Follow these steps....
put bind plug in the Rx
put power to rx ...see vcc written

red light on RX will start blinking

Switch on the TX holding the bind button on TX... notice the red led it will stop blinking.... meaning binding done.

switch off TX remove Bind plug change power to CH3

ON TX then power on RX ..... you should see response on servo