Need help with Phoenix Simulator

Started by sameeroraut, February 14, 2013, 05:21:04 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

sameeroraut

i have been using Futaba Radio for Phoenix Simulator from last few years, recently i encountered a problem resulting in some kind of a delay in outputs while flying any model on the Simulator... precisely a lag is experienced. This problem suddenly goes off n the transmitter responds normal but out of no where it again starts  :banghead:. i used all my three tx Futaba 6EX 7C n 8FG super same problem .. i m not able to figure out if the problem is with Sim Cable or the Software ...

Plz help  :help: :help:  :help:

netsecrets00

Have you upgraded Phoenix recently and started facing problem???

Sent from my GT-I9100G using Tapatalk 2
HK-450GT Pro 3D Belt-Drive Helicopter Kit (Align T-Rex Compat.)
Radio: WFT07 2.4Ghz

girishsarwal

Are you also facing a frame rate drop in the graphics or occasional stuck frames wherein the screen momentarily freezes?
gs

Hellyflyer

Have you tried clearing your cache and cookies or just run disk clean up. I think that should sort the issue
Helis and Quads ROCK !!

Shannon

no i have had this problem two reasons for this change ur usb port on ur laptop or pc put ur dongle to some other port another thing is and this is wat i was facing is check for earthing problem ur laptop or pc is giving a reverse current flow which cause disruption in the signal and cause lags of 2seconds and more ...this is what i was facing and i fixed it actually my graphic card was 4yrs old and reached its end of life so it was shorting within and thus messing my tx and sim it eventually caught fire in my pc it was cool  ;D .changed gph card no shorting or earthing problems everything is fine now
Wings are for wimps  :)-Mikado Logo/"OXY3  "/Scorpion Motors/Savox/JR PROPO/Spinblades/EDGE BLADES/KDE Direct/YEP/YGE/RJX/ GENS ACE Bavarian Demon-