Hallo
Members please do share your ideas my tx and RX of fly sky 6ch programble loosing binding at 50 meters .I have tried binding procedures also but still facing the problems please suggest and share the ideas..
Regards :help:
1. Check antenna isn't loose its the receiver , it can happen in crash..
2. Check antenna wire connections on both tx (board) and rx, bad solder joint..
3. TX voltage..
3. Different receiver..
Sir its brand new
I have not used that radio in flying..I have checked receiver antenna shoulderinf
Its in good condition.
2.I have done the ground test more then 50 meters after it its loosing binding.
3. I am using lipo tx pack for it on screen its showing full battey 12.3 volt after full ists goes round 12.6.
Done binding procedures also but still same result...
50mts ground test, you did that on a plain ground...
are you using ESC or rx battery pack ???
If it is 50 Mtrs on plain ground... well all is well.... on grount the range shown is generally very less. As the airplane goes in the air the actual range gets demonstrated. Do not worry just Fly your model.
Happy Flying
@shobhit 50 meters is all is well.. ???? well dear my frsky or hitec gives over 500 meters on ground.. and over 2.5 kms LOS in air.. there is surely something wrong with the radio.
try changing the receiver . if problem persists.. ur radio is the culprit.. antenna wire inside the radio might not be proper is faulty..
Avesh sir without ground test going air born will be a risk...might I have to check the radio antenna...inside...let's see I will check but I am facing this problem with the 9ch and 6 CH...
Wingman, I would agree with paladugu_sujith . Be careful, very careful
change ur rx and try. in fly sky so many radio having same problem in range. so dont take risk in air