Hi all,
Two days back I bought FS-TH9X radio and electronics. Today I connected all. I finished Binding process, when I power on the receiver a BEEP came from the ESC. all servos came to their neutral position. I haven't touch the throttle, After few seconds the ESC starts continues BEEPS. And motor starts rotating Anticlockwise and coming back. It continued until I power off the rx.

Then I reversed the throttle and tried. First BEEP came, I pushed the throttle not working. When I pushed the throttle back Both ESC and Motor made the same drama with interval of time.  

What to do? except this Everything is working.

anikethan : you have to calibrate the ESC. To calibrate ESC to the end points of your transmitter, switch on your transmitter, fully raise throttle and connect your battery to the ESC. After hearing the first two beeps, fully lower the throttle stick. You can check your ESC manual for precise instructions to do this and please also make sure to remove the prop from your motor before doing this. Also make sure to neutral any throttle sub-trims.

I heard only one BEEP . the drama is continuing.

Thanks Nitinraj, I referred the programming manual. It says if the votage above 11.1 or below 2.85volt, then ESC beeps continuously.

Mine is 11.1V 2200mah lipo. i checked it by lipo checker. It displaying as 12.5V. what to do? 

Just for the forum's sake please write the subject properly so that people can know what is the post about.
And about the Radio thing,check for any loose connections/connectors between the battery and ESC and even for the motor,

Do reply if it helps.

every thing is ok. why the battery showing 12.5V.

the battery will show up to 12.6v... which esc do you have? here's the standard calibration procedure
put throttle to max
switch on TX
connect esc..
esc will go bip... bip
at the second bip reduce throttle to 0
then the esc will go beeeep
then wait for anymore bips or beeps
if there are no bips after 10 seconds, slowly increase throttle...
hope it helps!

ps: is your esc a hobby king ss series one?

Sent from a potato using a lamp

Make sure you dont have a prop on while doing this,might be very dangerous.

might be? lol... do NOT have a prop on, or it will chop off your fingers....(i broke a nail just so you know)

i think you dont have throttle connected to right channel.

throttle should connect to channel 3 and  black wire should face away from you

Sent from a potato using a lamp