Hello All,
I have a new fly sky Tx 9 X and done 30-35 flights , but on last sunday , the Transmitter was not working after 150-200 meters. Pl provide your inputs for this issue.
Regards
Mohan
Hi Mohan, did you fix the issue? Or is it still there?
Hello sam,
That was receiver issue, antena cable was damaged by receiver housing, outer cable has a cut
Yesterday only i have repaired the receiver as suggested by members.piece having cut was removed and resolder again with receiver. Tommorrow , we will check the range.
Cool. Be sure to solder both lines (the inside coaxial line and the outer shield) to their respective points for proper range. Please do post a picture of your Rx antenna cable solder point if in doubt.
Happy landings.
Edit: the Tx part requires two lines to be soldered. I havn't tried the Rx antenna.. am assuming that it has similar soldering requirements.
just check the antenna. it should lock well have to press the lock properly. if u use this radio for simulator . when u install the antena u shuld hear some lock sound. tick. if u get then ok u can fly. same problm i had and crash some models
Yest Rx has two points for soldering inner and outer cable.I will post pictures of repaired antena.
have you tested the range after soldering the receiver antenna ??? ??? because am also having same problem with my 9x receiver :(
u range will still be affected if u reduced /shortened the antenna coax.
i will suggest u buy a new rx. not worth risking your model.!!