I have a r6b and t4b and i am making a Tricopter . I have a Mwc lite . I have connected roll to ch 1 , pitch to ch 2, throttle to ch 3, yaw to ch 4. When I turn the board and the receiver on... The receiver does not respond . When I push the throttle.. It doesn't respond ...help plz. 😫😫😕😕😦😦😟😟
Some body please help me... It's urgent
have you bound the receiver to your transmitter ?
is the led on receiver stay lit ?
Yes it is
what do you mean by ' doesn't respond ' ?
" When I push the throttle.. It doesn't respond ..." :- from this i assume you meant the motors are not starting, for the motors to start in any flight controller, there will be a procedure called 'arming' - this is for safety . in multiwii it can be either done by stick combination or by assigning a switch for it .
Or is it something else you meant to ask ???
with those inadequate information, no one will be able to help you with troubleshooting .
is the receiver outputs recognized by your multiwii board ? you can check this first using the multiwii configuration software .
Tell me how to arm it
I have a t4b
before arming, you have got to check whether your flight controller is taking the receiver inputs . also there is some preflight setups and checks to be done. for this the software called multiwii configurator will be handy. do you already have this ? if yes, we can move on with the setup. otherwise download this and update here :)
I have downloaded it. Now what??
connect your flight controller to pc. open up the software, select the com port, and click start . then you will see the sensor readings and receiver readings etc...
The blue light is flashing .. now what??