Receiver Question

Started by zonuna, October 09, 2009, 04:40:40 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

zonuna

Hi, I recently break my Futaba Receiver R114F 72Mhz. can anyone tell me If it is completable with another brand of 72Mhz receiver which they sell on ebay.in 

rcforall

Corona synthesised will work fine
www.zuppa.io : vehicle telematics, ADAS, IoT , Drones

anwar

Like Sai said, Coronas are very cost effective, and one of the best choices you have.

If you do decide on Futaba itself, just watch out for "lo" versus "high" bands.  If your channel number is between 11 and 35, you are in low band (and high band is 36 through 60).  When you get a replacement, make sure it is the same band based on the channel you are using.
Hangar : Please see my introduction.
RC India forum and me : About this forum.

RotorZone

The newer Futaba like the 168DF does not have Hi/Lo bands. There is a Hobbico branded version of the same rx for a few $$ less.

zonuna

thanks for you help, I think I am going to enjoy RCINDIA I am new here My band is 35

mpsaju

I use an Airtronics RD6000 35Mhz with a synthesised Corona receiver without any problems. I have never had any issues with this setup so far.

Saju
Happy Flying


Saju