i got my first tx & rx from rc bazaar
& converted it from mode2 to mode 1
& its working great
thanks to anup kumar working @ rcbazaar
for assisting me to buy
flysky TH9x 9chl 2.4Ghz radio system
http://www.rcbazaar.com/products/397-fs-th9x-9ch-24ghz-transmitter-receiver.aspx

hey!
i have booked one for myself from rcbazaar
and i wanted to ask
if i need a lipo 2100mah battery to operate reciever or 2 X 7.4v 210mah batteries are enough as i am using them for my 4 motors..
plz reply soon

lipo battery:
http://rcbazaar.com/products/1154-lipo-for-flysky-9ch-tx.aspx

are you making quadcopter...? if yes then people use 11.1 volt 2200mah battery...

No i am making a rc car with 4wd 12v motors so needed right info so if required i can order a battery for reciever

you should use 11.1volt  2200 mah battery.. with esc for motor
& and the battery link u have shown is for transmitter...
for receiver you can use  this  http://rcbazaar.com/category/71-batteries-lipo-safe-bags.aspx?pageindex=2

@shubham congrats! btw what did u use to fly the rc helicopters before?

Exactly can u tell me the mechanism and what thing i have to buy

@ aniket i used jr x3801 before... unfortunately it got burnt... now using the same above mentioned  set...
some people think it is not worth in front of futaba , hitec... etc.
but i can say china ka maal tikta hain

@ yash : u want to make something like this
http://www.rcindia.org/cars/scratch-built-moon-buggy-hovercraft-style/msg104965/#msg104965
http://www.rcindia.org/for-sale/lots-of-rc-items-for-sale-used-but-not-much/msg105857/#msg105857

@shubham... i use the same... its really not that bad!

nice  
i had started  this thread 2 years back
i am using this radio set  on 30,000 copter that also risk free..

HAHA! didnt notice that!!! i was wondering... it just didnt seem right...

i think that was my first post on this forum  
any how it has only 1 small problem, u have to check receiver antenna cable it may get damage due to bend at the receiver body  
i had an horrible experience in Bangalore while flying 

oh... have you flashed a different firmware?

no... just re solder the antenna it is working fine 

no i mean other than that, have you flashed a different firmwawre on it or are you using stock?

i am using old 1... stock!!!!!