Futaba, dots, heat and dust

Started by sushil_anand, November 02, 2010, 04:00:42 PM

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

sushil_anand

I have, finally, got onto the 2.4 GHz bandwagon. I have been reading a lot about the heat issues, etc. I would like to record my experiments and results on this.

To start with, the receivers I got with my Tx were (all) R 6014FS with a white dot. I asked around and got a "non dotted" Rx (6014FS) and conducted this experiment.

The Rxs were placed in my car with them being directly exposed to the sun, with the windows up. I have a room thermometer whose scale goes uptil 55 degrees Celsius. The end stop is perhaps a few degrees further on. After a minimum of an hour with the thermometer going right off scale, (indicating at least 60 degrees) the receivers worked fine. Binding was immediate without ANY problems, whatsoever. The RXs were fairly warm to the touch.

Yet, I have, personally observed problems with earlier Futaba sets. I can, with my very limited research, only conclude that:

The issues, if heat related, affected only some Rx. Or it was something else.

Maybe someone just went dottie!
Hangar: Zlin 50L -120, CMPro Super Chipmunk, Ultimate Bipe EP, Imagine 50, Christen Eagle 160, Ultra Stick, Super Sports Senior

SunLikeStar


sushil_anand

Supposedly, the early receivers had some issues. Futaba - again supposedly - released versions with a  dot between the antennae. Again, according to the grapevine, these were re-tested, improved or whatever.

No one knows for sure.
Hangar: Zlin 50L -120, CMPro Super Chipmunk, Ultimate Bipe EP, Imagine 50, Christen Eagle 160, Ultra Stick, Super Sports Senior

anwar

Here is a video that shows the problem, on a receiver exposed to direct heat.





The issue is real, but a non-issue with basic precautions.  I would urge you the same, if you have an older batch RX.

And this post has a video of testing one of the newer RXes.

http://www.rcindia.org/radios-and-receivers/are-you-still-skeptical-about-2-4ghz-radio-systems/msg10444/#msg10444
Hangar : Please see my introduction.
RC India forum and me : About this forum.

sushil_anand

Quite possibly. But what I was trying to get at is that it appears that not ALL of the older sets had problems. The one I borrowed worked flawlessly at 60 degrees plus. No different from the "white dot" one.
Hangar: Zlin 50L -120, CMPro Super Chipmunk, Ultimate Bipe EP, Imagine 50, Christen Eagle 160, Ultra Stick, Super Sports Senior

anwar

One way to look at this is to see if the problem chip was changed, or did they do any kind of heat-sink type of solution on it. This would require opening up the receivers though.

The chip is mentioned here (ML2724) : 

http://www.rcindia.org/radios-and-receivers/are-you-still-skeptical-about-2-4ghz-radio-systems/msg7765/#msg7765
Hangar : Please see my introduction.
RC India forum and me : About this forum.