friends i was making a new plane .its my first plane .i set up esc and servos .i gust checked for range with my flysky t6 tx .i got no range above 5m .i dont know whats the problem pls help

Are you doing the range test with bind button pressed ?

no

do i need to repair any thing

Are the batteries fully charged? How are you powering the Tx?
Did you ever try to power the Tx without the antenna if its removable?

Pics and videos of setup if possible, i can help you.
BTW i have the same radio and i can fly more than my eyes can see.
You must be doing something terribly wrong in basics.

Ashok.P

I think you must have not followed the binding procedure properly... Try binding it again using manual given... or the TX must be on under power battery or something. One photo of the setup would be helpful. I too use a Flysky T6 tx and had no such problem till now.
Also, did you disconnected the bind plug from receiver after binding it... I usually forget to do so...

Your antennae is most probably broken

how to find which side ?on the rx or on the tx?anyone pls help i am stranted

It seems the antenna wire at receiver must be broken. Broken connection inside.

guys latest update .inside the available range .i covered the rx antenna -by holding hand- and then i lost the signal.then i tried covered tx antenna with out covering rx antenna.then there was no loss of signal.i assume that the problem is with tx antenna .whats ur opinion?

friends i need help with my flysky t6.so pls pm me who have it?i need ur help

What exactly is your problem ?  You are opening new topics on transmitter issues without saying what the problem is !

Please stick to one thread on one issue.  Try it, it is not that difficult !

oky

friends .my rx antenna look like ugly.its the flysky r6b rx.it got reduced range.while inspecting.i found the shield solder is not good.if i need to resolder it ,i will need to cut it.so i gonna need a new antenna?(does reducing the antenna wire length affect the range?) i need ur advice pls help .i googled it .but i cant find right answer(the antenna which i have contained a tube like part on outside. Those antennas on other sites doesnt have that).thats why i need ur help?

See, my antenna wire broke and came out. I'd cut a small part of it almost 5mm and then resoldered it. No range issues till now. works finely.

Surely either antenna connection itself (central wire of co-axial) or shielding wire is disconnected.
You have to cut it at very small and have to solder it. Use 6-10 watt soldering iron with very sharp tip to avoid shorting between tracks.

friends i findout the problem was with my tx antenna .i need to change the antenna,does the normal wifi antennas work with it? Does this antenna work (link below)? I need ur feed back pls help.

anyone?

The antenna in the video will not work.

why?

What is actually wrong with your antenna?
how come you found that the antenna is the problem, well if your TX antenna is damaged and you used the TX along with it, chances are that you can damage your module itself. however any WIFI antenna from ebay.in can work with it but it should have a screw type connector for it.

Ashok.P

i already soldered the sma connector only need to connect the antenna

anyone got any idea?

oky