hi everyone
in my other remote suppose i loose signal or switch it off, the throttle will go back to zero position but in the flysky it is just maintained in the position where i switched off the throttle, say i off it at 50% throttle , the throttle is still maintained at 50%, it doesnt fall back to zero like with my avionic remote, so since the ppm signal is maintained at 50% even after loss of signal the apm 2.6 cannot enable the failsafe mode :-\( in my avionic say i loose signal, the ppm will drop below 1000, and the apm will enable return to land but im not able to do this with the flysky, since signal doesnt drop :headscratch:), is there any other way of setting up the failsafe in ppm mode?
Did you upgrade the PPM encoder firmware on APM? Refer the links below for more info.
http://copter.ardupilot.com/wiki/common-autopilots/common-apm25-and-26-overview/common-ppm-encoder-apm2x-atmega32u2/ (http://copter.ardupilot.com/wiki/common-autopilots/common-apm25-and-26-overview/common-ppm-encoder-apm2x-atmega32u2/)
https://www.youtube.com/watch?v=HtaXna9KsS0
Well...I guess that should be the case. The receiver failsafe is when you lose signal from your Tx then your receiver outputs a default signal to the controller. When you bind your Tx and Rx just confirm that your transmitter switches are set to the controller failsafe positions. I guess its good to have your throttle above 10%, 50%. I did that in case of my naza failsafe config. Not sure about apm!
Yes it worked , thanks guys :)